A growing collection of resources that are interesting or have been helpful while designing or debugging various systems.

• Daily Dose of Electrical Engineering
  • https://www.youtube.com/user/EEVblog
  • https://www.youtube.com/user/mikeselectricstuff
  • https://www.youtube.com/user/Photonvids
• Blogs
  • http://www.windytan.com/
• Beginner
  • Tronixstuff – Arduino Tutorials
  • Mbedded Ninja Blog
• General
  • Texas Instruments – Analog Engineer Pocket Reference
  • Electric Imp – Designing Analog Hardware
  • Comparator vs Opamp as a Comparator
  • Battery University – Everything You Wanted to Know About Batteries
• Control Systems
  • Brian Douglas – Control System Lectures
  • Mathematical Representation of Linear Systems
• Analog Design
  • Texas Instruments – Notch Filter Design Guide
  • Designers Guide to Instrumentation Amplifiers
  • Texas Instruments – Getting the Most Out of your Instrumentation Amplifier
  • Texas Instruments – Analog Engineer’s Cookbook
  • ECG Design
    • Analog Devices – ECG Design
    • Texas Instruments – ECG Design with Delta-Sigma ADCs
    • Cypress – ECG Design Guide
• Embedded Software
  • RMB Consulting – The ‘C’ Test for Embedded Developers
  • Introduction to the Volatile Keyword
  • Bitwise Operations in C
  • Embedded – Mastering Stack and Heap for System Reliability
• FPGA Design
  • ASICWorld
  • Hamsterworks
  • Verilog Pro
• Power Electronics
  • Complete Power Electronics Blog
  • Low Power DCDC Converters (Linear and Switch Mode)
    • Recom Book of Knowledge
• PCB Design
  • Circuit Board Mechanical Design
    • Mentor Graphics – PCB Mounting Holes
  • Circuit Board Thermal Design
    • Texas Instruments – Thermal Design by Insight, not Hindsight
  • Circuit Board Decoupling
    • Intersil – Choosing Bypass Capacitors
    • Clean Power for Every IC Part 1 – Understanding Bypass Capacitors
    • Clean Power for Every IC Part 2 – Choosing and Using Your Bypass Capacitors
    • Clean Power for Every IC Part 3 – Choosing and using Ferrite Beads for EMI Reduction
    • Become a Decoupling Capacitor Network Guru, Part 1
    • Become a Decoupling Capacitor Network Guru, Part 2
  • Good Grounding (Avoiding the dreaded ground bounce)
    • Hackaday – WTF is a Ground Loop?
    • Analog Devices – Staying Well Grounded
    • Grounding Guidelines for Mixed Signal Design
  • Transient Voltage Suppression Circuitry
    • Eliminate those Automotive Load Dump Circuit Protection Headaches
    • Littel Fuse – TVS Diode Application Guide
  • High Speed PCB Routing (Rising edge rates on the order of 50+ MHz)
    • Texas Instruments – High Speed Layout Guidelines
• Data Busses
  • I2C
    • I2C Bus – Beginners Introduction
    • Full Official NXP I2C Specification
  • CAN Bus
    • Vector eLearning – CAN Bus
    • Analog Devices – CAN Bus Implementation Guide
    • Texas Instruments – Introduction to the Controller Area Network
    • National Instruments – Maximum CAN Bus Length
    • ON Semiconductor – EMI/ESD Protection Solutions for the CAN Bus
  • LIN Bus
    • Vector eLearning – LIN Bus
  • Flexray
    • Vector eLearning – Flexray
• Antenna Design
  • Antenna Theory